floor corresponding glue and rubber sheet.

2, coil the shop is stuck, one end of the coil volume discount. Cleaning the floor and the coil on the back of the first, and then scrape gum on the floor.

3, tile shop is stuck, please will block material from the middle to turn both sides, the same to the ground and floor adhesive to stick on the back after cleaning.

4, different mixture in construction requirements will be different, specific please refer to the corresponding product manuals for construction.

Five, the pavement of the floor - exhaust, rolling

After 1, floor glue, use cork first push floor surface is smooth and squeeze out the air.

2, then with 50 or 75 kg of uniform roller rolling steel floor and become warped edge trimming joining together in a timely manner.

3, floor surface excess glue should wipe in time.

4, after 24 hours, and then to slot and weld.

Six, the pavement of the floor - slit

1, slot should be carried out after the glue solidified completely. Use a dedicated slot machine along the seams of slot, to make the welding firmly, slotted should not gone, suggest slot depth for two-thirds of the thickness of the floor.

2, at the end of the slit apparatus cannot operation site, please use the manual slit apparatus with same depth and width of slit.

Slot before 3, weld, must remove residual dirt and broken material.

Seven, the pavement of the floor - weld

1, can choose welding torch by hand or automatic welding equipment to weld.

2, the temperature of the welding torch should be set up to about 350 degrees or so.

3, with appropriate welding speed (ensure electrode melting), uniform electrode to squeeze into the great trough.

Four and a half, the electrode cooling, the electrode was used month make the device or type of cutter parts of the electrode is higher than the floor surface in the cut.

5, when the electrode is completely cooled, the in the use of electrode make the device or type cutter cut electrode bumps on the rest of t